Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a layered network where the majority of servers have access to two networks (through their own separate NICs). Everything is connected to an SF300-48 switch with four (including VLAN1) VLANs set up. Everything is sitting behind an ASA552...
Hi,I'm wondering if this is possible : I seem to remember reading somewhere that it is, but do you think I can find the article?(please see attached NET01.JPG file)I have an ASA5510 with a few servers sitting behind it and some users that authenticat...
Hi,I've read a few of the comments about multi-homing an Ethernet interface, but I can't seem to get to the bottom of the issue that I'm having. I'm attempting to add a third IP address to my Ethernet0/0 interface. In my config I've the following:i...
Bill,Exactly what I'm after and is exactly what you have listed here (use of the "secondary" switch) From my config:interface Ethernet0/0 ip address 192.168.2.1 255.255.255.0 secondary ip address 192.168.30.1 255.255.255.0 secondary ip addre...
Looking around some more on the net, I too came up with this - but there's nowhere in my config where "ip address negotiated" appears. (It would seem that this is used when initialising a PPP connection)I've even tried pulling out both addresses (I ...
