Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Recently, my existing CSC SSM module license has been expired &I need to know the steps needed &product ID to renew an expired License CSC SSM module hosted on ASA-SSM-20 appliance :Tip,The system was licensed with Base &Plus license ,500 users.
Hello All,I'm going to deploy 2 ASA's as active/active configuration but i read in a cisco document VPN Failover will not be suppoted in multiple context.My question is does active/active setup will not support VPN failover or VPN at all ?
I have main router which has a primary &secondary WAN links connected to remote site also with P&S WAN links connection to the main site one connection through IP-VPN (MPLS ) using BGP routing(Primary)&the other link through lease line using static r...
Hi, I've cat6509 SW &it was working fine but someone by mistake has modified the setting for telnet &console access right(set access list to deny any access) &now no one can access to the switch but i only able to telnet to the MSFC so is there anywa...
Hi,I've cat6509 SW &it was working fine but someone by mistake has modified the setting for telnet &console access right(set access list to deny any access) &now no one can access to the switch but i only able to telnet to the MSFC so is there anyway...
Hello pkampana ,Thanks for your reply .But does mean that the suggested renewal part number ASA-CSC20-500UP-1Y will also renew the base license ?Thanks in advance
Thanks qoutam for your response.Actually i got your point but i need to know what will happen if the primary link again returned up i mean, does it will take the place of the active link or what ?
Can you plz see the attached file to see the topology .Does the changing AD value for both routing will meet my demands ? which was to let primary link forward the traffic to the remote site &secondary link as backup line &in case primary link goes d...