Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a feeling my cat3650 died just wanted to get some other opinions before I toss it. I think the line that concerns me is the Boot bus: Failed to detected IDE storage, which I assume is the flash ? Booting...cf_identify_drive: cf_waitfor(CMD_REA...
Looking for some assistance with setting up 802.1q tagging I having issues passing traffic from the HP2920 to the Cat3650. The Cat3650 is the main hub where I have the SVI setup for each Vlan.I have 2 vlans, WLAN(130) and a Guest_WLAN (140) and Nativ...
I've been task to go through some inventory and I've came across a Catalyst 3650 that I can't seem to rest and not sure why. Since I don't know the username or password I am entering ROM mode I initialize the flashBooting...flash_initbootswitch: flas...
The switch I'm currently having issues with is not automatically booting the OS image after a power outage, I have to manually boot flash:<OS> every time. here is my switch information. during boot I get:The system is unable to boot automatically. T...
here is the results from that, looks like it fails boot usbflash0:cat3k_caa-universalk9.16.12.13.SPA.binReading full image into memory.................................................. ...................................................................
I finally got it figured out; after getting the trunk port configured and matching on both sides, I dug into the HP side, and I found the underlying issue there. like you I'm not fully familiar with HP either. I started at the bottom of the stack and...
ok, so I removed the "vlan dot1q tag native" so vlan 160 Native should now be untagged.I also added vlan 160 to be allowed on the trunk port as suggested. I also read a suggestion about turning off DTP since trunking with HP means LACP, I did try wit...
that's because I'm just using it just for 802.1q tagging/Vlan separation, the cisco devices has the SVI IP for the vlan and the DHCP pool for each vlan.
