Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!Can you please help me, I'm new to VOIP:We have Cisco CUCM version 12.5.1 with 7960 and 7911 phones. How can I see missed calls on the phone if the line is busy (talking with someone)?SO called person is talking when I call him, the phone rings...
Hello!We have Cisco ASA5508X with FTD on site. Twice in one month happened, tha ASA suddenly stops passing traffic. When the reload command is issued, it starts working for a few seconds then reloads itself. After reload works normally. I didn't find...
Hello! I would like to configure two trunk ports on Cisco ASA 5506-X for Cisco Access points. I have two BVI interfaces for two VLANs (1,10). When I'm trying to configure the second one I receive an error: ZAVAS-GW(config-subif)# interface GigabitEth...
Hello!I have do some QoS on a Cisco 851W router with IOS Version 12.4(15)T12.The problem is that QoS is very limited on this router (no class-map, policy-map).My goal is to get priority (or let say 1Mbps bandwith reservation) on a traffic on LAN dest...
I have a Cisco ASA AnyConnect client with configured Radius Authentication (NPS) with Microsoft AD. It works OK.Then I add password-management command to the Tunnel-group general-attributes. It still works OK.But when I check "User must change passwo...
We have FMC with two SFR sensors on ASA5508X. I did an upgrade to FMC and both sensors to recommended version 6.4.0.9-62. I thought this will solve the problem but it didn't. After a week it happened again, this time the traffic stops only for VPN lo...
Hello all!It happened again. I set then SFR to monitor-only and it helped. I checked this twice so I'm know that it was the SFR that caused that. Now I'm searching trough Connection Events in Log and I can see, that suddenly there was only DNS reques...
Yes Marius, you are right. ASA with SFR module of course. My bed.I think that could be the reason. The Syslog is huge. I will lower the logging and observe the behaviour of ASA.Thanks for the tip.
There was no changes in network for quite a time. There was the same problem both times, not at the same time.The problem is that this ASA is in production and I don't have time to explore. I must react quickly. I didn't find anything in syslog but i...
Advance security: flash:c850-advsecurityk9-mz.124-15.T12.binI think it would be possible. But the problem could be:128K bytes of non-volatile configuration memory.20480K bytes of processor board System flashRegards,AM
