About marh

marh · 12-21-2020

Hello!Can you please help me, I'm new to VOIP:We have Cisco CUCM version 12.5.1 with 7960 and 7911 phones. How can I see missed calls on the phone if the line is busy (talking with someone)?SO called person is talking when I call him, the phone rings...

marh · 07-08-2020

Hello!We have Cisco ASA5508X with FTD on site. Twice in one month happened, tha ASA suddenly stops passing traffic. When the reload command is issued, it starts working for a few seconds then reloads itself. After reload works normally. I didn't find...

marh · 12-04-2019

Hello! I would like to configure two trunk ports on Cisco ASA 5506-X for Cisco Access points. I have two BVI interfaces for two VLANs (1,10). When I'm trying to configure the second one I receive an error: ZAVAS-GW(config-subif)# interface GigabitEth...

marh · 01-13-2015

Hello!I have do some QoS on a Cisco 851W router with IOS Version 12.4(15)T12.The problem is that QoS is very limited on this router (no class-map, policy-map).My goal is to get priority (or let say 1Mbps bandwith reservation) on a traffic on LAN dest...

marh · 01-05-2015

I have a Cisco ASA AnyConnect client with configured Radius Authentication (NPS) with Microsoft AD. It works OK.Then I add password-management command to the Tunnel-group general-attributes. It still works OK.But when I check "User must change passwo...

marh · 07-27-2020

We have FMC with two SFR sensors on ASA5508X. I did an upgrade to FMC and both sensors to recommended version 6.4.0.9-62. I thought this will solve the problem but it didn't. After a week it happened again, this time the traffic stops only for VPN lo...

marh · 07-15-2020

Hello all!It happened again. I set then SFR to monitor-only and it helped. I checked this twice so I'm know that it was the SFR that caused that. Now I'm searching trough Connection Events in Log and I can see, that suddenly there was only DNS reques...

marh · 07-10-2020

Yes Marius, you are right. ASA with SFR module of course. My bed.I think that could be the reason. The Syslog is huge. I will lower the logging and observe the behaviour of ASA.Thanks for the tip.

marh · 07-09-2020

There was no changes in network for quite a time. There was the same problem both times, not at the same time.The problem is that this ASA is in production and I don't have time to explore. I must react quickly. I didn't find anything in syslog but i...

marh · 01-13-2015

Advance security: flash:c850-advsecurityk9-mz.124-15.T12.binI think it would be possible. But the problem could be:128K bytes of non-volatile configuration memory.20480K bytes of processor board System flashRegards,AM

Member Since	‎06-04-2003 01:18 AM
Date Last Visited	‎09-28-2022 12:01 AM
Posts	17

User Statistics

User Activity

CUCM - Logging missed calls on phone

ASA with FTD suddenly stops passing traffic

Configure trunk port fo Access point on Cisco ASA 5506-X

QoS on Cisco 851W router

User must change password at next logon with AnyConnect and RADIUS authentication

Re: ASA with FTD suddenly stops passing traffic

Re: ASA with FTD suddenly stops passing traffic

Re: ASA with FTD suddenly stops passing traffic

Re: ASA with FTD suddenly stops passing traffic

Advance security: flash:c850