Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently migrated from a Firewall Services Module Version 4.1(8) to a ASA 5585 running 9.5(2).
We have been up and running on the ASA for about a week now. The only issue we've seen is with ACLs whereas some of them didnt port over and we had to e...
There's 3 sites. Every site has its own CME (running CUE per site).My question is how do I get the sites to act as 1?What I want is for there to be one directory. Right now there are three separate directories so if a extension/user is on one CME the...
Hello I have a customer with 6 different sites.We have installed a UC560 plus a ESW switch at each site.We are replacing an older VoIP system. The existing system allows the customer to do 4 digit dialing between sites.I know this is possible but my ...
I dont have a CCM so I'll look into the alternate solution.When you say "load the directory" do you mean just add all the users to each CME?I'm just asking how do you specifiacally do that?I'll also have to research VPIM. If you have any links or inf...
Hello guys I was able to get this working using the following configuration (this is the headend UC560 but its very similar on the other UC's):!dial-peer voice 5555 voip description Intersite to Site1 preference 1 destination-pattern 20.. session tar...
Hey guys I just tried this to test and I wasnt successful.Here are the configs I added at each site:dial-peer voice 4333 voip description Site1 to Site2 destination-pattern 16[0-2]. b2bua session protocol sipv2 session target ipv4:192.168.4.10 dtmf-r...
Hey guys thanks for all the insight.I've read over the documents supplied and I'm going to try to configure things between two sites for testing.Any other insight is welcome as I've just learned so much in a few hours.
Thanks for the answer. I'm looking at the doc you posted for instructions.as far as bandwidth is concerned there will be T1 between sites.With that said what is a good codec to choose?
