About The Learned

The Learned · 03-11-2016

Hi everyone, newbie question. is it possible to use snmpv3 to write to ASA? all the articles i have read so far seem to talk about how to configure snmpv3 on asa to send snmp traps and for getting info from asa. i am looking to push out configuration...

The Learned · 12-18-2015

Hi, I am trying to install firepower on redundant asa5512x pair that are configured in active/standby mode. these asas have an IPS module installed. I need to remove the old IPS module and install the firepower module. I know that I need to shutdown ...

The Learned · 12-21-2012

Hello everyone, I am new to networking and was wondering if someone could explain to me how switch/router handles multiple subnets.Lets say i have 3 subnets/ip ranges mentioned below10.0.0.1 to 10.15.255.25410.16.0.1 to 10.31.255.25410.32.0.1 t...

The Learned · 03-12-2016

thank you aditya!

The Learned · 12-22-2015

i think that is the problem. in our setup, management and data networks are separate and dont talk to each other. i will move firesight vm to the management network and it should work.

The Learned · 12-20-2015

thanks again Marvin. i am able to get further this time following your guide. i am having a separate issue now after i connect to the sfr console. i am not able to ping the gateway. i need to troubleshoot it further but the guidance you provided atle...

The Learned · 12-19-2015

Hi Marvin thank you for your response. i use asa 9.2.2(4). i was trying to shutdown/uninstall the existing ips module (tried it first on standby asa and that didn't work so tried on active as well) but in both cases, it looks like ASA reboots after r...

The Learned · 12-22-2012

thank you so much. i will give it a try when i get a chance.

Member Since	‎12-21-2012 01:04 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	9

User Statistics

User Activity

snmp v3 and ASA

Installing Firepower on redundant ASA 5512x pair

Connecting various subnets

thank you aditya!

i think that is the problem.

thanks again Marvin. i am

Hi Marvin thank you for your

Connecting various subnets