Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I've got two WAEs in the lab, running without a CME, as Edge accelerators, connected to 3560s with WCCP. Going through all the docs and playing with it, I get the following results:1) WCCP is up and enabled2) Matching flows are seen on both WAEs3...
Hi.I have intermittent packet loss to an ASA (in fact, to two different ASAs) one running 7.2.4 and one running 8.0.3; packet loss is in 2-4 hour intervals that last for 15 minutes. Spikes are usually 2-7% packet loss. There are a couple of cpu-hog m...
I have a strange situation. I had a 1721 out at a site, that had mounting interrupts, degrading VOIP performance until it needed to be rebooted every three weeks. We upgraded it to a 2621xm, and the same thing occured -- although after four weeks, in...
I have an E1 line that, when connected to a 2800, works ok (60 slipped seconds per interval.) But when connected to a 2600 series router:E1 0/0 is up. Applique type is Channelized E1 - balanced Far End Block Errors Detected No alarms detected. al...
This is a known problem with none but an ugly solution. There is no "preempt" or active peer detection for ISAKMP, even though it should prefer the first peer when both become active again. If you look at the IPSEC SAs, you'll see it thinks it is sen...
The answer was: There is a bug in the Cisco IOS. http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsj08002&from=summary