About Darren Frowen

Darren Frowen · 09-09-2016

Hi All, We have a pair of ASA5525-X with Firepower Module. I am trying to manage the device via ASDM as we do not have VMWare to manage the devices. As normal with ASA i racked and powered on and formed HA between two appliances. I have remote acces...

Darren Frowen · 08-30-2015

Hi, Hoping someone can help, we have a serverfarm failing with ARP_FAILED. The server farm is configured to use Vlan275 and the real servers are routable from the ACE via this interface. We can ping the real servers from the ACE and also all health c...

Darren Frowen · 08-03-2015

Hi,I am having problems with a route not being learned by a neighbour device. I have three layer3 switches each connected and peering with each other using ospf over a VRF. Each device is connected via SVI’s point to point links. So I have three devi...

Darren Frowen · 04-03-2012

Hi,I was wondering if anyone could advise on the following issue that we are trying to overcome. We wish to be able to translate both source and destination of an outside (Internet) initiated packet. With the following configuration, we can clearly s...

Darren Frowen · 09-05-2011

Hi,Can anyone help me with the following issue. We have a Cisco 6500 running the following image;Cisco IOS Software, s72033_rp Software (s72033_rp-IPSERVICES_WAN-M), Version 12.2(33)SXH4, RELEASE SOFTWARE (fc1)We are attempting to configure Netflow a...

Darren Frowen · 09-15-2016

Yes correct, thanks for your repsonse. Just my lack of experience of the new Firepower Module Jetsy

Darren Frowen · 09-15-2016

Hi Jetsy, Sorry for the delay, all went well in the end, once i upgraded to the 6.1 version, went through the setup of the SFR module i could then see all the tabs in ASDM. Regards

Darren Frowen · 09-12-2016

Hi Peter, Thanks again. So i think my problem was the fact that although in recover mode waiting for .img i was then just thinking it was failed or stuck. I was also try "session sfr" but then tried "session sfr console" and was then presented with ...

Darren Frowen · 09-12-2016

Hi Peter, Thanks again for your response its is appreciated. Are you saying it takes hours for the .img initial recover or the consequent upload of the .pkg? Regards

Darren Frowen · 09-12-2016

Hi Peter, Yes i waited a good 45mins and was still the same. So i have now rebooted the ASA itself and now i have a sfr module thats unresponsive. Going to try it again. fw-01/pri/act# sw-module module sfr recover configure image disk0:/asasfr-$fw-...

Member Since	‎09-05-2011 07:42 AM
Date Last Visited	‎01-15-2020 12:05 AM
Posts	19

User Statistics

User Activity

ASA Firepower Module managment via ASDM

Cisco ACE ARP_FAILED

OSPF route advertise ment issue.

NAT - Translate outside source and destination.

Cisco Netflow with VRFLite

Yes correct, thanks for your

Hi Jetsy,

Hi Peter,

Hi Peter,

Hi Peter,