Hi All,
We have a pair of ASA5525-X with Firepower Module. I am trying to manage the device via ASDM as we do not have VMWare to manage the devices. As normal with ASA i racked and powered on and formed HA between two appliances. I have remote access so just a couple of rules and NAT statements.
I then decide to start and look at the Firepower Module, i session in and accept the ULA and configure the basic settings from the Module via SSH, IP MAsk and GW on the same network as i have the inside interface. I log out and the ASA can ping both the Managment IP's of the Firepower Modules. This is where i think there is a problem. According to the documentation, I should then be able to browse via ASDM to the Licensing but i cannot see anything other than the status tab on the Home screen, certainly no " Configuration > ASA FirePOWER Configuration > Licenses and clicking Add New License.
Configuration > ASA FirePOWER Configuration > Licenses and clicking Add New License.
I have rebooted and tried to reset the module to try and start again but still nothing and the reset function doesn't seem to work at all to factory reset the module. I also tried going through the startup Wizard but the Firepower Step9 of 12 doesn't appear.
http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/5500X/5500x_quick_start.html#pgfId-131978
Can anyone advise what i may be doing wrong?
Regards
Darren
