About kjot

kjot · 04-27-2006

Hello,i have a strange problem. I am running two ACS. Severals users on ACS1 should be authenticated on ACS2. So a user is created on ACS1 and has a RADIUS Token Server configured for authentication what is ACS2. On ACS2 the user is available.When i ...

kjot · 07-07-2005

Hello,how can i manage/observe a 'Cisco Secure ACS Solution Engine'? Ich found no things like SNMP etc.regardsKarsten

kjot · 02-25-2004

Hello,i have the following problem: Users come in via WLAN on several AP1200 and are authenticated against a ACS, which forards the authentication request to a Novell RADIUS. For the WLAN is LEAP used.Unfortunatly the usernames which come from the WL...

kjot · 05-04-2006

Hi, i have to explain. I don't care about the telnet traffic, this is of course clear text.The Problem is what you see when typing the password in your telnet session. This is not just blank, like in normal cases, the typing of the password is shown....

kjot · 06-16-2004

Hello,i checked this document, and it looks that the decribed commandauthentication open network-eap [word](under SSID config)is not supported, even when document recommends that latest Version. From the command list its also not supported.Do have an...

kjot · 03-03-2004

okay, thanks so far.Is there a possibility to add an suffix per NAS on the ACS? Or something similar? (And keep LEAP authenticating on the ACS)

Member Since	‎06-05-2003 04:04 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	7

User Statistics

User Activity

Using ACS forward, telnet shows password in clear text

Manage a Cisco Secure ACS Solution Engine?

Add a default suffix? (RADIUS)

Re: Using ACS forward, telnet shows password in clear text

Re: How do I enable WPA on a 1200 AP?

Re: Add a default suffix? (RADIUS)