Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello to everyone.I am working on this topology for 2 months but i wasnt able to find the accurate solution even i asked from prefessional but their solution wasnt accurate.My qustion is ----> How i can activate Private-vlan while using SVI with VRRP...
Hello to everyone does anyone knows about eve.ng that how can i export the lab with configuration ?i searched about eve in community but i didnt find my answer
Hello to everyone I used the dynamic means dhcp method in order to assign ip address to the router interface whenever i used the show ip route command i encounter to a new option as above picture [254/0] My question is what is exactly the 254 means ...
If I change the path cost, then the regional root will change. If I want to change one master port for IMSTI-2 in SW-3, then this won't effect the master port. So the result is we can change the master ports.Rule1. Regional root is the master port fo...
hi hope u fineI just enter to this link it has alot of information about uplinkfast and backbone fasti searched more and more to find this documents link if u have the entire these document link would u like to send me .
first thanks for giving response :should i assign the ip addresses to these interfaces as i highlight them ?if i assign the ip address in these interfaces actually we limit one interface for only one vlan.
When I created private vlan primary and secondary so whenever I try to assigne ip address in secondry vlan the won't accept that cause its only possible in primary to assign ip so how can I give the ip and than group the routers for vrrp
