Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Got a "new to me" AP1852i I'm trying to reuse as a home AP in Mobility Express mode.Initial test shows me it work perfectly well in 2.4GHz, but I'm unable to see anything broadcasted in 5GHz.Already confirmed setting "Canada" as the country for Domai...
Cisco TAC was willing to work with me as long as I could provide original Company name that purchased it.Well, don't have that info... so thanked him for his time and will push the issue towards my reseller.Thanks everyone for the help here!
@MHM Cisco World wrote:Show capwap client config <<- share this Here's the result following yet another "capwap ap erase /all" and then reset config from Mobility Express interface. Powered directly from a 48V "Local Power Supply" brick and set to c...
@Flavio Miranda wrote:Try to lower the channel width to 20 or 40 mhz.I've tried with both 20 or 40 mhz as per your suggestion with no improvement. Switching manually to different channels too. Noise floor is permanently -128dbm on the 4 antennas.
@Flavio Miranda wrote:I can see two possible issue** show lldp inline_power *****
Power_Requested(mW) Power_Available(mW) Port_ID
Negotiation-failed Negotiation-failedSomething related to Power, If you are using PoE. Usually when AP face problem wi...