Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, I am new on cisco and I have cisco 9120AXE-F and it's new. To power on the product, I connect to POE+ injector AIR-PWRINJ6 and for configure I have console cable to usb with my laptop and it is running well and i can see boot process for th...
I am already install the virtual wireless controller version 8.10.183.0 but it still same result My cisco virtual wlc IP is 192.168.1.6 My cisco AP in same network in 192.168.1.5 same as my ISP Router. I'm trying to reset my AP too but no luck.
I think from this link https://upw.io/4tv/AIR_CTVM-K9_8_5_161_0.ova the version is 8.5.161.0 because i was following this tutorial https://www.youtube.com/watch?v=YNB-sppMizU for installation of virtual controller
I just want to configure the AP to get bridge mode and spreading the wifi signal, is that necessary for configure using the controller? what if i don't have it? is there any alternative solution? because I am trying to install virtual controller air-...
