Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello,i have the requirement to load balance https sessions via CSM. Can anyone advice how to maitain stickiness; since SSL headers will be encrypted, how will the CSM extract the cookies. If this will not work, any other way to do so?thxbassam
HelloI have installed an ATM module (NM-1A-OC3SMI) in a 3745 router with IP Base image. Since the module was not supported, i upgraded to IP Plus image "c3745-is-mz.123-16.bin" as per software advisor. Still the module is under unknown for the router...
helloI have a failover PIX 535 running os version 7.01; it was not able to synchronize and i found that an interface shows the following upon sho interface:Interface Ethernet2 "testVlan", is down, line protocol is uphave anyone seen the interface dow...
Dear AllI'm configuring transparent-caching as in the attached configuration, still it is not working.any advice?When a client try to connect, i have a flow bilding between the client and destination (shown by show flows), but i'm not able to find an...
hello alli have the following secnario: an 11506 CSS that should load balance (transparent caching) to 2 bluecoat proxies. For notmal http trafic it is working fine. When the connection is about https or the web site has a redirection ( as in the cas...
Thanks a lot, but i found that i should be unchecking the "strip realm" and put the domain name in upper case letters for the Active directory goups.Thx again, it is working fine now
Thx patric for your input. It has been working for half an hour fine with no disruption.How did you configure the arrowpoint-cookie to expire when the client browser is closed?Gilles, do you think that increasing the "flow timeout-multiplier" and con...
Thank you guys,Now that i've testing many options, including the one you have adviced, i have the following:Both solutions you did advice works for quite a time, and stops sudenly for 10 minutes and work again after few minutes. ever seen this with c...
Thx Gilles,But my requirement was to match a URI, so the url may start with something different. Is this the same? or should i use url '"*/oiddas/*"'Do you think i should keep the "string in the service or also remove it?Thank you
