Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco router 2900 with a Cisco HWIC-16A 16 port Async interface card on the back that i plan to use to console into nearby switches in case they lose connectivity for an OOB solution.I have tried many documentation regarding this setup and I...
I am using the command you wrote in the CLI of the console server to tryand connect to the switches, but it's being refused because the switchesare set up to only accept SSH.
Yes i am trying to connect to the switch using the command you providedthat is connected to the console server on the HWIC-16A interface. When Iput in the command you gave me I use the management IP address of theswitch in question. This is the same ...
The target switch refuses the telnet connection, because it uses SSH. However when I try ssh <ip_address> 2010, it prompts me to put in a password but I get an error message Line has invalid autocommand "2010"[Connection to xx.xxx.xx.xx closed by for...
