Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It looks like there are certain features that are only available when running in Native mode on Sup2. Is there any reason to use CatOS going forward other than for backward compatibilty?Thanks,RJ
Here is an excerpt from an MLS link:Understanding Hardware Layer 3 Switching on PFC2 and DFCs:" Hardware Layer 3 switching allows the PFC2 and DFCs, instead of the MSFC2, to forward IP unicast traffic between subnets. Hardware Layer 3 switching provi...
Here is the setup:I have 2 LANs with 4 routers and many remote offices. Router A is on LAN1 connected to one side of the outsourced WAN via s0/0. Router B is on LAN1 connected to router C that is on LAN2 via a point-to-point link. Router D is on L...
What are the main benefits of having a layer 3 switch vs. a layer 2 switch other than not needing a separate layer 3 device to route packets between vlans?Thanks,RJ
Hello,It looks like the statements are setup to do what is called Identity NAT in v6.3. I have included a link from v6.1 which is a little more descriptive. It is basically allowing you to access resources from a higher security interface on a lowe...
Thanks for all the responses.Across a WAN, you need to specify the LAN interface as the source since protocols will use the serial interface for the source since that is the interface where the route points to for the server. NTP works the same way ...
