Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
sysObjectID 1.3.6.1.4.1.290 of 7507mx cannot be resovled with mib II. 7507mx's ios is rsp-jsv-mz.122-8.T10.bin.I'd like to know if there's any package for RME3.5 to get 7507 managed. Any advice is highly appreciated.
After replacing a crashed ws-x6k-s2u-msfc2 for a 6513 swich, the new engine cannot be displayed in CiscoView 5.5, but other modules shown correctly. The snmp configuration in not changed and the ios version is c6sup22-jsv-mz.121-11b.EX1.bin.How can w...
I couldn't get any infomation about the Frame Relay subinterface down/up by issuing 'show log' on the 7206 router. So is that normal? Any advice is highly appreciated!
Thanks a lot for your hint. Well, I cannot add the 7507mx into the inventory. The import status is not responding with this box.ping and telnet to this box is ok and no acl to snmp packet between nms and 7507. so it's due to the sysoid difference.I'...
Hi Ansley,Thank you so much for your kind help!After checking some related documents, I found that the my question posted here is meaningless. The fact is that my customer has a NM-HD-2V on his 3640A router. But he inserted VIC-2BRI-S/T-TE in to the...
Thanks for your advice! Yes, your idea is good, but by using the method you mentioned, I still cannot get value of some hsrp instance! But later, i found the reason. It's due to the access-list configured on the vlan interface. You have permit the ...
I think you can find USB to RS232 serial(DB-9) on the market. Then you can connect it to the RJ45 console cable provided by cisco. Well, I found a question and answer same as yours, please check:http://forum.cisco.com/eforum/servlet/NetProf?page=net...
