Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear team,I would like to make WLAN change on C9800 fully managed and configured via DNAC/Catalyst Centre.When I wanted to check, that deployment config is empty without any previous change in Network settings/profiles in DNAC, it showed me that DNAC...
RFDear team,I would like to use AI RF profiles in our DNAC for C9800 deployment. When I wanted to assign first locations to new AI RF profile, I got message, that AI Analytics have to be enabled first and then profile can be used.Unfortunately, when ...
Dear team,customer is changing subnet, which is using for one of SSIDs on C9800 WLC deployed and managed via DNAC.I would like to change that vlan via provisioning of WLC with new setup. The current SSID is used in different policy tags and sites man...
Good day to all,
we deployed C9800 WLC in Catalyst Centre, while it is managing APs for one specific site, which has multiple buildings and floors.
Now, we would like to put under management of same WLC some APs, which are on different site in DNAC H...
Good day,
we have currently multiple agents, which runs on switches and also one agent on TE virtual appliance, which is used also for SNMP polling via SNMPv3. We discovered more than 500 devices in customer network and 40 000+ interfaces via SNMPv3....
That was not a standard behaviour. After provision of WLC, Tacacs key overwritten and I lost tacacs access to WLC until I changed the tacacs password on Cisco ISE server to match the one, which was pushed from DNAC to WLC by provision.It is not optim...
