Hi Ken,When you run "vlan 10" on the VSM, it is creating the vlan and programming it on the n1k. In a manner similar to what you would expect from an upstream switch, VLANs must be created/enabled on the switch before traffic will be allowed on that ...

Hi Joel,Yes that is correct. The CLI was introduced for 1(3.x) to 1(4) upgrade. What version of the VSM are you running?Thanks,Sachin

Do you have "no shut" in the port-profile to make the profile active? Could you post the running config snippets?

Hi Sanjeev,Is the module showing as up in the VSM when you execute 'show module'?Is you ESX management VLAN allowed on the access port profile and on the uplink? Is it created on the switch?Do you have system VLANs for your control, packet connectivi...

Hi Jim,A couple quick questions:Are your VSM's using portgroups on the vSwitch or the N1k?Are both clusters in the same vCenter datacenter?If the above answers are both yes, I can see there being issues since a portgroup with the same name on the vSw...