Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Morning All,I am about to start installing two new (and very nice) Cisco 2960-S switches into a network as explained below:6 - Servers10 - Network Printers10 - Wireless access Points1 - WatchGuard Firewall (x750e)80 - 120 client PC's and Devices.Curr...
Hi Everyone,I have got an interesting problem with some Samsung POE IP Phones (ITP-5114D). If I plug one of them into the C3550 switch, the port comes up for about 2/3 seconds and then goes down, and the switch does this until I either shutdown the p...
Hi,I'm in the process of looking to purchase three new 48 port 10/100/1000 switches. These will be connected via GBIC's in a hub and spoke configuration (ideally), all located in the same cabinet.Switch1 - Being the hub and having all 8 servers conne...
Thanks for the information Marcin.We didn't have enough money in our budget to go for the L3 switches as we needed gigabit across all ports, so we went for the 2960-S. At our other site we have the older 3550's which run perfectly, just a shame I co...
As far as I am aware the switch is running the latest version of the IOS. If someone could confirm that it would be great.I will see if I can find these in the UK although it might start to get a little costly as we will have 20 of these shortly.
Just for some further information. I have managed to get the POE Status from the current 3COM switch which they are plugged into.Unit: 1Compatible mode : EnabledInterface Admin Oper Power(mWatt) Power(used) Priority High Power---------- -------...
Hi,Ok, I have pasted the debug information below:EXHXSW2#Jun 15 08:06:57.366: ILP uses Link Disconnect(Fa0/13): state= ILP_DETECTING_S, event= TWTI_PWR_GOOD_EVJun 15 08:06:57.366: Ilpower PD device 2 class 9 from interface (Fa0/13)Jun 15 08:06:57.36...
