Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
I would like to force certain prefixes over a directly connected interface using statc bfd routes.
Unfortunately, the bfd session does not come up, and so aren't the static routes.
The softare on both routers is (ASR 9904) is 5.3.4.
config...
Hello,
I am trying to get the ipv4 dhcp relay function to work on an ASR9904 using IOS-XR 5.3.4.
What I have configured is the following:
interface GigabitEthernet0/0/0/3 negotiation auto l2transport !l2vpn bridge group vlans bridge-domain DWD-Telefo...
Hi,I'm looking for a way to configure a CSS to direct traffic to "overload" servers when the number of maximun connections is reached for a service. Is this possible?Thanks,Ilona GlaserGerman Weather Service
When trying to configure a virtual-router under a circuit, a message says that ip redundancy has to be configured first. But, after configuring this, it says the command ip virtual-router doesn't apply with box-to-box redundancy.What is the correct w...
Hi Aleksandar,
quite correct, thanks a lot!
I don't need any bfd statics back, so have configured a dummy one. the bfd session came up immediatly.
Many, many thanks,
Ilona
Hi Xander,
again, many thanks. In the lab, it worked immediatly with my original config. The only difference here is that the phone indeed is sending tagged packets...
So, now I at least have a working config, and can try to find out why I don't see...
Hello Aleksandar, Xander,
thank you both very much for your replies. I have tried all of them, but it is still not working.
GI0/0/0/3 is not getting tagged packets, the ip phone is directly attached there. I have change the config to
interface Gigabi...
