Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have a requirement where we have one DC in Singapore (APAC) and other in London (EMEA). Currently, all remote sites connect to London via MPLS for Internet access. However, now we need to route APAC sites to use Internet from Singapore a...
Hi All,
I have a CPE router connecting to Fex2k and when i try to ping peer IP's of each other i see ping drops in a pattern and when i increase the packet size i see more drops but again in a pattern.
Any particular reason this i happening and will...
Thanks Iespejel for the response.
So, if it is between APAC and EMEA then ISP will have Core router sitting between these 2 regions right. In which case, we just have to manipulate the default route metrics from these routers rather than doing on al...
But when i ping from other location router to the same IP, I dont see any drops ( Goes on same segment). If its network issue or cabling issue then basically from any location i ping to that IP i should see drops right?
