Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,My client has a need to PAT via a L2L tunnel on a PIX515E 6.3(5. Allusers on the inside should be able to connect to 2 VLSM IP scopes and one test machine via a VPN tunnel. The remote site is allowing all connections to appear comming fro...
A WAAS withe dual disk DISK-SATA2-250GB. One disk failed and I want to replace the drive.The question is, once I swap the drives will the new drive get rebuilt automatically?Thanks
I am looking at ways to span 4 vlans currently configured at one site to another site.The VLANs are configred on a 6509 which is connected to 3845 with a T3 connection to the remote site. The remote site where I need to span the VLANs to has a 6506....
The FWSM did not initialize the DEC correctly and I am planning on issuing the command "No monitor session servicemodle" Is this intrusive and to what extent. Will it resolve the issue or do I have to upgrade the IOS. I am running 12.2.18 SXd7B
I figured the static works for one to one and does it errors on one to many, the mask error). I used the policy nat and told the client he needs to upgrade.Thanks for the help, I appreciate it
I don't know why PDM rejects the Policy NAT and disable PDM configuration until these 2 lines are removed. My client depends on PDM for simple configurations so PDM configuration must be available. Did you see the attached error earlier?Thanks
Testing is browsing to 10.254.1.1. I just realized my tunnel is no longer up, I have to fix that. Attached is the error from PDM regarding the policy NAT
I also tried this policy NAT and did not work. I was able to create it using CLI but PDM reported as an invalid configuration and I had to remove it. The configurastion I listed in my initial post works for another client but they have an ASA inste...
