Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Q1: Port that host are linked must become access link, configure them with the best practice so that the ports will directly go forwarding at startup.Answer 1 : Switchport mode access Switchport access vlan x Switchport portfastAnswer 2 : sw...
Frame Relay rate limiting : ·Maximum throughput is 128kbps·During congestion, your provider will mark any traffic in excess of 48kbps as discard eligible,Make sure your throughput changes accordingly, based upon BECNsreceived, only.·Your token buc...
(Web cache system)+ (User) --- (e0/1)R1(e0/0)---(Internet)R1:Ip wccp web-cache Int e0/0 Ip wccp web-cache redirect out * my question is , do i need any command for e0/1 ? since the web cahce system + user is ther ?* do i miss anythings ?
Hi Gurus,My Reflexive Access Lists is not woking, do you have any idea on it ? am i did the wrong config ?* i juz wan my telnet session reflect in the ACL. ip access-list extended OUTR2 permit tcp any any eq telnet reflect test deny ip any anyip acce...
Hi guru, i got question here :RA ---- RB(EIGRP 10)QUESTION :RA do not inform any topology change over the RB ANSWER: 1. RA configure passive interface2. ? (Other than passive interface, stub? )Thanks in adavance for advices.
Hi All gurus,Actually the requirement is cannot use passive interface to accomplish it. As for the solution from "rburts ", u mean sending a summary route wiht 0.0.0.0 to RB, but for your information, RB also connect to other eigrp router.
the port must waits for 16s before the interface begins forwarding. In MSTP environmentthe default forward delay is 15, so can the asnwer looks like this ?spanning-tree mst forward-time 16
so can i make it as 2001:ABC:123:2:3/64 eui-64 ???but the question is "remaining bits of network address should be made of 3rd octet of IPv4 address of the interface"so wat is the right address i should use ?thanks in advance for the reply !
Your IPv6 prefix is 2001:ABC:123::/64, host portion must be made in EUI-64 format, mask on all interface must be /64, remaining bits of network address should be made of 3rd octet of IPv4 address of the interface.IPv4 Address : 10.1.2.3So wat is my v...
