I have 80+ APs on a single IP range. Can I have two WDS APs on a single IP range in order to service the 80+ APs? I was planning to configure 40 APs to point to one WDS AP and the other 40 to the other WDS AP
I keep getting this log entry over and over "Interface Dot11Radio0, Station AP-name, Mac add Associated KEY_MGMT[NONE]" By the way I took out my AP name and MAC add for security reasons.WHy does my AP keep associating to itself?Thanks
I am trying to use the WLSE 2.7 to convert VxWorks APs to IOS. I am using the config templates to upgrade the APs, but once the APs are converted I can not log into the converted APs via the web interface. I can however log in via the CLI. after s...
I keep getting Java errors when I view various reports in WLSE 2.7. I am currently running Java ver 1.4.2. Do i need to upgrade to a newer Java ver? Has anybody else seen this before?
After some initial testing of this new ACU, I have noticed that this new version still takes about a minute and a half to get through the authentication splash screen before your desktop appears. It sits on "Finding Domain Controller". This also ha...
What type of security are you running?....If you guys are using an EAP type of security, yo must make sure that you check "Open" under authentication type, and check "require EAP" under that as well. this will allow non-cisco clients to connect, but ...
You want to be careful of migrating the 350s to IOS. There have been numerous posts and I have had first hand experience with the IOS code messing up the 350's Many times the IOS 350s rebooted themselves at random times, kicked clients off, and los...