Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Everyone.I was recently browsing through the internet in search of a new fast AP that is able to wirelessly bridge to my non-cisco wireless network and I began reading about the features of the Catalyst 9130 AP. Then I came accross this docume...
Hello, everyone.I recently got a few cisco 5506-X firewalls from ebay and would like to upgrade them to their highest versions as possible. These firewalls came with firepower services module with versions ranging from 5.4.1 to 6.2.3. I have been rea...
Hello, Everyone.I am currently trying to setup 2 networks, 192.168.1.0 and 192.168.2.0, so that they can ping each other(and eventually talk to each other). However they are to communicate with each other using firewalls, specifically the ASA 5506-X....
I recently got a cisco 2621 to act as a terminal server, which has a 32-ASYNC NM module attached. I made the configurations on the router to be able to access network devices using an octal cable via telnet [IP address] [port number]. This is the out...
Hello, everyone.I recently was able to get internet access for my computer by connecting to a cisco 3702i access point via ethernet, which bridged to my home network which had internet access. This was done using Universal Workgroup Bridge and it wor...
Hey Christian, appreciate the response.I read the doc you sent and I only saw uWGB being supported on the IW9167, unless this also implies that lower number versions of the 9100 APs also support this, not sure.As for why I'm looking for uWGB instead ...
Appreciate the observation, Ambuj. My next question is: If this means that the 9130 **does** support uWGB, then is there some sort of documentation that shows how to do that? I have seen cisco documentation where it is done for Mobility Express devic...
Since Packet Tracer is very limited in commands, that same security traffic permit intra interface command does not work. So I recreated this entire network physically(same firewalls, same switches, and some end devices for ping tests). However, even...
