Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup a wireless link between two locations, and be able to pass VLANs through the Wireless link. Currently I have two 1310 bridges.I followed the information at http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configura...
We recently had a user go to a congerence at another location, and when they connected to the Wireless there, they were automatically redirected to the locations Website.I have been looking through the WLC Config guide (7.0), and the only thing I am ...
The only problem I see with the way it works is that it does not do the redirection each time the same computer connects. Once the computer connects, it remembers the information, and just connects silently if it is disconnected for any reason.
OK, thanks, that does work. However, I was under the impression that it would pop the web auth page when attempting to connect to the WLAN. THe auth page only shows up when attempting to access the web, then it redirects to the auth page, then after ...
Thanks Scott and Rob. However, I must be blind, since I am not seeing what you are refering to. I tried to setup a test WLAN following the document you linked Rob, but, we do not have a DMZ controller.The WLAN is already up and running (we installed ...
