Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configure OSPF in broadcast domain & all three routers are elected DR , its not taken highest IP address of interface in this configuration what could be the issue.
R2#sh ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface172.16...
Hi, I am unable to ping from client VPN to inside the network any one of the following IP address after establishing the VPN connection.The following IP address are not able to ping 192.168.2.24192.168.2.13192.168.2.100 - this is f...
syslog configuration.unable to getting logs from server.....I am getting error in ASA5505-FW#sh logging as mentioned below.May 29 2009 02:08:19 172.26.8.254 : %ASA-3-710003: TCP access denied by ACL from 172.26.8.3/1594 to inside:172.26.8.254/23
please look at the configuration there is no loopback IP, manual router ID and higher OSPF priority,
so it has to elect the DR highest active IP on the router, so its not happening & all the routers are become DR as per the sh ip ospf neighbor in R2...
I can ping inside between to PC's .13, .24 and firewall gateway .100 as well.The problem is only from remote client not even any of those PC's and firewall gateway.
Hi I just modify the different IP pool as you said and route also, still am unable to ping those internal IPs.......is there any other changes. ip local pool remote_support_pool 192.168.130.1-192.168.130.200 mask 255.255.255.0 route ouside 192.168.13...
I have done the configuration as per the ulr.The same error is getting. Please check the configuration and confirm anything needs to update.interface Vlan1 nameif inside security-level 100 ip address 172.26.8.254 255.255.255.0!interface Vlan2 nameif ...
