Hello everybody,Iam trying to config a PAT on ASA5506 for my network (Labo CCNA) .Finally PAT rules is not applied on packets, its forwarded without any change.you can find attached running-config of ASA5506.FW#show running-config
: Saved
:
ASA Vers...
Bonjour à tous,
J'essaie de créer un réseau WAN sur mon labo et je rencontre un petit problème : lorsque je ping le suivant hope un paquet sur deux est perdu.
Type of connectivity : Fiber
Network : Ipv4 Class public
type of route : default route
Vo...
Hello everybody, I am just starting to create my LABO for an objective to pass the CCNA exam soon.I have a little problem that the VLAN 99 Management is accessible for all L3 devices but cannot reach (L2 SW 01) Devices.You will find attached my labo ...
yes you are right, for all my past topology i tried this method and it's functionally i mean (you need to Management to reach across all devices, then you need to have Layer2 Trunk between Router and Switches (L3) then use router as gateway for all -...
Thank you for you answer.When i said i modified it I wanted to say that i removed vlan 80 and now the interface Gig1/0/22 as you see on the screenshot is the gateway of Srv network.the problem exact that all switches are reachable between them, even ...
Hello,I modified that now all switches are accessible between them but when i try to reach them from another vlan i have a problem of gateway. you will find attached a photo of out layers.
First of all thank you for your support. L3 SW01 Interface Gig1/0/23 is route interface and have an ip address same network of R1 Gig0/0 that's why it’s not on trunk mode.
