Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've came across a very odd topology to deal with where everything is connected to everything, without proper utilization of VLANs. - I've an L3 SW and a 3745 RTR at core - Both are carrying same subnet to an L2 distribution switch that connects serv...
I've EIGRP as my corporate network protocol. In my branch offices I've two links, Leased line and Fiber. Fiber link connects through the tunnel with metric 297246976 whereas DXX connects with metric 2172672. Though, fiber has the better bandwidth and...
I've a Cisco PIX 515E that has recently crashed and stuck into continuous rebooting loop. It starts loading IOS from flash but initially it saysImage must be at least 7-0-0-0 error in file flash:/pix622.bin then after a little while it throws an erro...
I've the following scenario VPN Concentrator is connected to a router which is connected to a router and at the edge Cisco 515E PIX is connected to the internet. The problem is that the normal VPN Dial-up connection (a utility of windows) are gettin...
Joseph,Thanks a lot for your post. Correct, I'm not counting LAN traffic as a culprit. I believe interrupt can be seen by issuing "show processes cpu" command. There's absolutely no utilization in the mentioned columns, the highest was in decimals, ...
Nagendra,Many thanks for your reply. I will categorically reply to your post.1. You are right my server farm is connected in this fashion, as depicted in the diagram attached. The gateway for Server Farm is 1.1.3.240 (3745). For 1.1.2.X again, 3745 i...
Though, I'm unable to access it now but on Show Version command it shows the version 6.3(5) which to me, means it's running that particular version of the IOS. As for the monitor mode, I was rather prudent uploading a new IOS initially due to Serial ...
Here's the detailed overview of the scenario:Access list mentioned in the question asked allows 10000 port but another access list with same credentials also allows pptp connections. NATing is done as: static (inside,outside) ...
