About Brian Harriss

Brian Harriss · 08-25-2011

Here is my customer's setup:They have a UC320w & SPA8800, 6 FXO lines coming in. 3 of the lines have a caller ID "Company Group A" and 3 have "Company Group B". Out of thier 15 phones, 8 of them are for Group A and 7 for Group B. When they make outbo...

Brian Harriss · 11-23-2010

Hi all,I just got a 1941-SEC/K9 router and EHWIC-4SEG 4-port ethernet switch card to go in it. When I installed the card and did a 'show diag', the router reports 'WIC module not supported/disabled in this slot". My IOS version on the router is versi...

Brian Harriss · 01-19-2016

I was troubleshooting this problem recently for a client and came across this thread. My client had a UC320 & recently purchased 2 SPA525G phones to work with it. Both phones exhibited this problem: every 2 minutes, the phones would report "Refreshin...

Brian Harriss · 08-25-2011

Hi Chris,Yep, that was my primary question, along with "How can I make shared FXO lines route somewhere else, like AA?" Fortunately, I stumbled on the answer to the second question while reading some of your other replies in this topic thread. My sol...

Brian Harriss · 11-24-2010

Yep, you were correct. After I updated the router IOS to 15.1(3)T, the card was recognized.

Brian Harriss · 11-23-2010

I had seen that too, before ordering the card & router together, which is why I contacted Cisco before purchasing, to ensure that the card and router would operate correctly together. The rep typed on their computer for a few minutes and said "yep, t...

Member Since	‎11-23-2010 07:00 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	6

User Statistics

User Activity

UC320W - Send all lines (including shared) to AA?

EHWIC-4ESG card disabled in 1941 router

I was troubleshooting this

UC320W - Send all lines (including shared) to AA?

Re: EHWIC-4ESG card disabled in 1941 router

Re: EHWIC-4ESG card disabled in 1941 router