Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a home lab with the following setup:vlan 5->data vlan 10->voiceCME Router Cisco 1760 has been configured as a DHCP server to assign IP for both for data and voice vlan.CME Router1760 configuration:int f0/0.10ip address 192.168.10.1encap trunk ...
I am little bit confused with this topic. I need a report which displays all the calls made by users on daily basis. When I see in the discussion forums, people are talking about CAR tools but I am not sure if it can be used in CUCM 7 or not. When I ...
I am ruuning asa5510 box with ver 7.0 which was recently migrated from pix. This week, I created a new static address mapping from ASDM interface for my new web server located at dmz. Internal ip that I am using for web server is 172.16.1.6. If I com...
I recently migrated our firewall from pix 6.3 to asa 5510. After the migration only the users having ip address 10.100.0.x can connect to the internet except the others having the IP address 10.100.1.x and 10.100.2.x. Everything else works fine as be...
I recently migrated our firewall from pix 6.3 to asa 5510. After the migration only the users having ip address 10.100.0.x can connect to the internet except the others having the IP address 10.100.1.x and 10.100.2.x. Everything else works fine as be...
I found that the service was already installed and running. I assigned myself as a member of CAR admin group. When I try to logon to the CAR webpage, I get the following error message:The requested resource (/car/j_security_check) is not available.Is...
Yes, when I access the page from inside, it goes to http://172.16.1.6/lms/login.pl?template_redir=172.16.1.6I tried to access from outside replacing the internal ip with public ip. I was glad to see at least few texts and button there. May be its som...
