Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is the link to the newly published Cisco Intersight Storage Best Practices Configuration Guide.
This guide outlines various storage configurations and best practices for Cisco Intersight® Managed Mode (IMM) with Cisco UCS® fabric interconnect ̶ ...
In this introduction instruction video, HyperFlex 4.0 API Explorer will be explained and how you can use the HX API Explorer to automate an application.
Where to start with getting an Access Token and how to get datastores showed via API calls.
CU...
When there is a new host, you have to create a new zone, or put it in the same zone (If allowed.)Please have a look at: https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/san-os/quick/guide/qcg_zones.html
Hi Ronnelcompayan.It does not have any influence on the Initiator side, as long as the Target (SAN) is still supporting the EOL drive, there is no issue.
Kind Regards,
Joost.
Hi JN242,You can connect the MDS next to the other brand FC Switch on the FI.The best practice is to have different VSANs to the MDS.The second question is personal choice. Personally I like working with port-channels even if there is only 1 link in ...
Hi Ryan,
When you want to have to separate environments from the Fabric Interconnect up North, you cannot have the same VLAN IDs.The solution is to work with Disjoint Layer 2 network: https://www.cisco.com/c/en/us/support/docs/servers-unified-computi...
Hi,
You don't have to bring the HyperFlex cluster down for the MTU change.
The order doesn't matter, as long as it is in one flow.
Personally I would start with the switches, FI and then VMware.
