Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, expert could anyone help me for the UCS problem? description my problem. 1、 the type of device is UCS 5108 MINI. the blade server is B200M3. 2、 when the profile was created complete , include design to the blade. 3、 login to SAN...
hi, everyone;
when i try to change UCS 6120 to FC Mode: switch ,then try to connect to MDS 9124, checking MDS 9124, always display following error.
" isloating because of hte zone modes does not match the receive rjt from adjact switch. " wh...
Hi, everyone,g
could you help me, introduce testing evrionment ,
A SAN switch is MDS 9124.
A UCS Mini 6314
A EMC VNX 5100
on the MDS, cannot found out one of WWN of the blade server ? because of when initialization UCS profile, a...
hi, expert：
what's wrong with my UCS-MINI, Have already configuration boot order with SAN BOOT.
but actual boot order display :
"Not found. Please verify device presence"
please refer attachment picture :
Hi, everyone:
could you please help me to solve kvm cannot logint issure ? try many way and has ever configure KVM ip address, according to the following
step "In the navigation pane, click the LAN tab, expand LAN > Pools > root > IP Pools...
HI,MJ:1. UCS firmware version?A: 3.2(3h)B2. UCS in FC switching or end-host mode?A: end-host mode3. Status of FC/FCoE uplink?A: FC4. Are you using native FC or FCoE?A:FC5. Uplink switch model & version. If mds, please provide "show flogi internal err...
hi, Walter Dey:
Q. You talk about UCS 6120, but your output above shows a 6248 ?
A: just my faulty. actually it's FI 6248, just go to compute room to ensure again
Q. do you have one MDS, or 2
A . only one MDS.
your virtual interfaces are in VSAN...
hi, Walter Dey :
according your advice, change to end_host mode, but when i login to FI 6120, execute the followong
comand , no display any ouput . could you help me again ? what's wrong with FI ? at the MDS 9124 ,have already enable NPIV fea...
hi,Walter Dey
- topology: e.g.
A:
do you have one or two MDS ?
A;one MDS
is UCS FI-A connected to MDS ? is UCS FI-B connected to same or another MDS
A: both of FI are connect to same MDS.
have you created 2 different VSAN's, eg. 10 for Fabric A, ...
hi,Wesley Austin
two problem:
1. according to your advice , i press F6 keyboard when process of UCS blade startup .
please refer to attachment picture vdvd.png, only display locate CD/DVD, no display storage LUN disk.
2. login in to FI6324, e...
