Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an 1300 Access Point Bridge using 12.3(JA) software. I'd like to use it simply as a repeater (getting signal from an AP1200 to repeat). Under the radio settings, I'm setting it to "Root AP (Fallback to Repeater)". However, when I unhook the...
I just updated the firmware on an 1200 access point, using the AP1200-Cisco-IOS-Upgrade-Image-v1.img image file I downloaded from Cisco.Now, when I try to browse out to the AP using a browser, I'm prompted with a username/password box. I have no ide...
Are you even being prompted for the username/password? We ran into a similliar situation, where we weren't even being prompted for the username after we updated. Ended up sending the units back for replacements.
