Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have already finished my NAT, DNS, Default route labFrom End users I can ping xoilac.xx and banhmy.xxx with DNS I set up in google DNS serverand CORP Router has NAT configuration like this:interface FastEthernet0/0ip address 6.9.6.10 255.255.25...
Hi, My name is Quan. I am new to OSPF and dynamic routing.I've been learning about RIPv2 configurations and OSPF configurations.While i am doing in this OSPF Multiple Areas lab I had a problem regarding the routing table doesn't show results as I tho...
I can see there's a time when both source ip and dest ip is 6.9.6.69 . I think it translate the source ip from 172.16.69.2 to 6.9.6.69after looking up the NAT tableafter looked up the dest ip in the routing table it found the entry (because i have ip...
Thank you for your answer and your resources you recommendedI just want to ask some last questions:1. " but because both the source (172.16.69.2) and the destination (6.9.6.69) actually point to the same inside host, the router does not perform NAT i...
I see, thank you for your reply. In addition to this problem, i want to ask the followings:1. The traffic never leaves the inside network. Does it mean the router knows it and not even trying to forward it to outside network (the internet). Below are...
I think i am running on 8.2.1btw I closed it and checked and yeah it appears the O*E2 nowmaybe the problem was I haven't fully configured before connecting these devices using cables so it contradicts ?
