I would like to create a endpoint tracker that monitors the next hop out the WAN/VPN0 side.  And based on the state of the tracker, influence BGP attributes.I've been using the newer configurations.  I can create tracker, but do not see where I can s...

I have two routers setup with each having one port going to a particular service provider and then TLOC extensions and high availability.  How can predetermine which router is going to be active upon startup?   And if it does failover, how do to you ...

I'm trying to lab Multi-Region Fabric.  But having an issue with my routing.Before creating my tunnel interfaces and IPSEC encapsulation,   everything works as expected in regards to my routing. Which is completely BGP.  From the router at the 15201 ...

I am trying to find a good example or lesson on configurating TLOC extensions utilizing the Configuration Groups (Not classic templates) and the C8000v.  You can use the guided tour when using Configuration Groups and enable TLOC extensions there,  b...

I understand that vEdge and vBond are basically the same device.   And depending on if the command 'vbond <IP> local' dictates whether the device runs as an vBond or a vEdge.  When trying to use it as an edge device.  I am unable to set the encapsula...