I understand that vEdge and vBond are basically the same device. And depending on if the command 'vbond <IP> local' dictates whether the device runs as an vBond or a vEdge.
When trying to use it as an edge device. I am unable to set the encapsulation. In fact encapsulation is not an option under tunnel-interface. I ended up going back to version 20.7.1 as I considered it more stable than version 20.13.1 or 20.15.1.
Am I doing something wrong. Because I have no problems setting encapsulation on other versions, just not 20.15.1
