About Hoang Van Truong

Hoang Van Truong · 12-18-2012

Hi all.I want to configure UCS Manager to send an email to me in case of having error (critical/major/minor)I read configuration guide, and it says that I must have a CCO ID to register smart call home.I don't want to register SCH, I just want UCSM t...

Hoang Van Truong · 09-18-2012

I have a chassis with one 2104XP module and B200M2 serversCan I put a 2204XP module and B200M3 servers to this chassis? .Thank in advance.

Hoang Van Truong · 10-30-2012

This is normal behavior when you choose legacy adapter for VM.Here is information from Microsoft: A legacy network adapter works without installing a virtual machine driver because the driver is already available on most operating systems. The lega...

Hoang Van Truong · 10-30-2012

If port is Ethernet uplink port, you can set the speed at 1/10/20/40 GbpsIf port is FC uplink port, I think that you cannot change the speed.

Hoang Van Truong · 10-02-2012

Hi Abhinav,These are screenshots of fans, psus and cpus.Thank in advance

Hoang Van Truong · 09-30-2012

@AbhinavI followed your instructions to upgrade ucsm and all firmware to ver 2.0(4a), and all works wellThank you so much for your help.Do you have any document about all parameters of hardware components in ucsm? I add a PSU into an existing chassis...

Hoang Van Truong · 09-19-2012

Thank AbhinavI have a fabric interconnect 6248UP, run 2.0(2q) software in standalone mode.I buy a new FI 6248UP for cluster configuration.So do I need to upgrade firmware to match each other before? Cluster configuration requires symmetrical connecti...

Member Since	‎05-22-2012 01:37 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	9

User Statistics

User Activity

Configure email alert

Mix 2104XP and 2204XP

Hyper-V Legacy NIC

Speed of Uplink port question

Re: Mix 2104XP and 2204XP

Mix 2104XP and 2204XP

Mix 2104XP and 2204XP