Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I found a thread on this subject from back in Dec. 2010, but there didn't appear to be a resolution. I have a similar situation where I have to migrate a JunOS FW to ASA and while I can decode the interfaces, static routes, NAT, but I am having a di...
Is it possible to rate limit, or police, the bandwidth for some users while not for other users? Can this be done based on the type of traffic? Source/destination?TIA
We have a 4402 controller and we are doing MAC filtering. We have reached the default number of MAC addresses, 512. It has been recommended that we add an additional controller instead of increasing this past the default. Three questions:1. Is th...
I have setup a L2L VPN for a customer in which the vendor requires their IPs to be natted when they come across. So, I have setup policy nat on their pix for the L2L VPN. Here is a snip of the NAT config: access-list nat-to-vendor permit ip 192.168...
Thanks for the reply. However, I found that this issue is a bug in PIX version 6.3.3. The bug ID is CSCec63822. The work around is to use policy nat for the internet traffic, or upgrade. I used the workaround, somewhat similar to what you have pr...
