Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco Community,I would like to know if it is possible to change the IP address of an existing Cisco Catalyst Center deployment without having to rebuild or redeploy from scratch.Our current setup details:Catalyst Center is already deployed and...
My current Cisco ISE deployment is running on version 3.1 Patch 4. We are planning to upgrade to Cisco ISE 3.4, and I would like your guidance on the correct upgrade path.Please confirm whether a direct upgrade from 3.1 Patch 4 → 3.4 is supported, or...
Hi Community,I have configured Local Web Authentication on our Cisco 9800 WLC for the Guest SSID. However, when users connect to the Guest SSID, the client device is displaying the security type as “None”.Please find the attached snapshot for your re...
Hi Community,I am currently using a Cisco 9800-L WLC in my network, where 7 Access Points are already joined and working fine. I would like to add 6 more APs to the same controller.Could you please confirm whether I need to purchase additional licens...
Hi Community,I have a Cisco 3800 Series AP that has entered ROMMON mode and is currently showing the Uboot>>. I would like to install the IOS image 8.5.171, which matches the version running on my 2500 WLC (8.5.171).Could someone please guide me with...
Hi @Sylvain_Che ,Thank you for the detailed explanation and for sharing your experience. This is very helpful. I appreciate the guidance on using the CIMC KVM and the reminder to review the static routes and external connectivity. The note about forc...
Hi @Leo Laohoo & @Rich R Thank you for your replies.The issue has been resolved. LLDP was disabled on the PoE switch. After enabling LLDP, the AP LED is now stable as expected.
