Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I keep getting messages that my access point refused to connect.
I put in on the same switch I'm connected to (a C2960). I can see it gets an IP Address, I can ping it, but I get a refusal on the web address. The fact that the browser says refused t...
Hello,
I just started a new job and there is a box of Aironet 1242AG access points they'd like me to configure. I plug it into a C2960 PoE switch and I can see it gets an ip address. I try to type that ip address in my browser to configure the acces...
That is a great link. However, I cannot access the web interface. I get a message that the access point refused to connect (see picture). So it looks like I'll have to flash the access point via cli using a serial port. I bought a usb-serial port cab...
This is what I got:AP0019.e713.f444>show versionCisco IOS Software, C1240 Software (C1240-RCVK9W8-M), Version 12.4(21a)JA2, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2009 by Cisco Systems, Inc.Compile...
I think you're right. Let me know if the picture I attached is what you're referring to...I can see that the access point picks up an IP address and subnet mask from the DHCP server but then it keeps looking for its controller (which we don't have)....
I am brand new to Cisco. How do I get access to AP CLI? I tried to PUTTY into it using my desktop's serial port, but a blank black box opens and nothing happens. Wouldn't all setting be cleared since I wiped it?
