About StaismanS

StaismanS · 08-03-2011

Here is my setup: I have switch SF300 with two VLANSVLAN1 - IP 192.168.1.1 also swtch's IPVLAN2 - IP 192.168.2.1I have cisco router for WAN - IP 192.168.1.19in the switch SF300 i have default route 0.0.0.0/0 to 192.168.1.19in the router i have rout...

StaismanS · 07-21-2011

Ok i am having a problem with ACE rules.I have 5 VLANs, I assign VLANs to its ports and make them all Untagged.I created ACLs and a ACE rules for each ACL, and then assigned to the ports. So what i am trying to do is to deny access to from one port t...

StaismanS · 06-21-2011

Right now we have around 50 users in our workplace, here is a mess right now, I dont even know how it still in working condition. For 50 users we are using 5 switches and I have no idea why, I just came to this place and I want to re-organize whole n...

StaismanS · 08-05-2011

Ok here is my routing list, I dont have any NAT config or any ACL'sthe 42.0 route is for another network from other place which is working fine also.....192.168.1.5 is my firewall ....I added 192.168.2.0 to the RIP networks but didnt helpIf your fire...

StaismanS · 08-04-2011

The router is Cisco 1841, I know this is strange because HOSTs in VLAN1 isworking fine, have internet and everything.VLAN2 hosts can ping .19 but don't have the Internet...Also I have firewall after router, could firewall block my VLAN2 because it ha...

StaismanS · 08-04-2011

Anybody?

StaismanS · 07-25-2011

You have every port setup as a trunk port and member of all vlans except for the g1-2. If you only have one device plugging into the port, then you can make it an access port member of that vlan. Not only one device, I have other 4 switches connecte...

StaismanS · 07-22-2011

I am sorry but I dont understand, what should I do? Change port setup? Make all ports untagged? I am new with manageble switches.I have 5 VLANS,VLAN1 (default) - ports from 1 to 24 - VLAN IP - 192.168.1.1VLAN2 - port 25 - VLAN IP - 192.168.2.1VLAN...

Member Since	‎06-21-2011 08:17 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	13

User Statistics

User Activity

Can't get access to the Internet from VLAN2

ACE rules problem with SF-300

Need advice with network segmentation

Re: Can't get access to the Internet from VLAN2

Re: Can't get access to the Internet from VLAN2

Can't get access to the Internet from VLAN2

ACE rules problem with SF-300

Re: ACE rules problem with SF-300