Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I have a Cisco 829 ISR stuck booting to ROMMON-1. I do not have a Cisco account needed to download the images from cisco.com so we asked our contractor to provide the images. They sent us the two files below which to my understanding is the IO...
I'm working with Cisco 819's and 829's that need a large configuration file for the AP803 side of the box. The engineers that developed the current setup procedure tells us to open a session (service-module wlan-ap 0 session) then copy and paste the ...
I'm a new user of Cisco products in a public transportation agency and I'm working with both the Cisco 819 and 829 routers. These devices are installed on a large fleet of vehicles.We have written procedures for setting up both models, but the engine...
I finally figured out how to load the router and AP configs from text files and I detailed it in another post in case anyone is interested. This method uses TFTP to transfer both files (router and AP803) to their respective startup-config. Thanks to ...
I figured this out. Here's how I did it.Service laptop ethernet adapter is setup with IP 192.168.99.1, subnet mask 255.255.255.0, and gateway 192.168.99.2At the IR800 prompt:enable
config t
int gi1
switchport access vlan 99
int vlan99
ip address 192....
Leo, the USB drive method doesn't seem to work. The "show file systems" command doesn't reveal the usb stick and I was reading some other posts on this site that mentions the USB port is only accessible via "GOS" not "IOS". We are running the softwar...
