Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I came to know that cisco 5508 WLC does not possess 'IP address filter' for Lightweight access-points added to WLC.
also if i had to add multicast address to dot11radio0/1 interface to the cisco 1242 AP. how to do this ?
apart from that i want to...
Hi,
I am using cisco 1242 access-point. i have set maximum value of tx-power at this AP. while sniffing wireless
packets via wireshark, i am not able to identify the tx-power from radiotap header v0 or ieee802.11 wireless lan management frame.
apart...
Hi,
i have ccx wireless client that i am trying to connect with cisco 1242 AP by deploying ciscosecure acs 4.2 server.
From the acs server, system configuration-> Global Authentication Setup-> peap -> allow eap-gtc is selected.
similarly under eap-f...
Hi,
i am testing ccxv4 client by following the document of "Cisco Compatible Extensions for WLAN Devices Test Plan for Versions 1-4"
i need to test the following scenarios:-
1) beacon report -> beacon table scan, passive scan
2) frame report -> same,...
There are few services which were not able to restart , they are as follows:-1) CSAuthError:- "Windows could not start the csauth on local computer. for more information, review the system event log. if this isa non-microsoft service, contact the s...
Hi paul,
i am using cisco air-ap1242 access-point and the Cisco IOS Series AP - System Software
System Software Version:12.4(10b)JDA Bootloader Version:12.3(7)JA1
Now as per the appendix-K from CCXv1-4 test plan, how to upload ...
