Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
for the upgrade to work, you need to also download the PRI .nvu file that is listed together with the .cwe file on cisco's download page. Then, create a folder on flash or bootflash of your router and run the microcode command using the folder instea...
Just in case someone is still looking for the answer of this although 6 years later. What you need to do is:
1- Put all your interfaces in a VRF (eiBGP multipath only works for VPNv4 routes)
2- in your address-familly enable: maximum-paths eibgp 2 (o...
