About tiredes2015

tiredes2015 · 07-18-2017

Hello, I have a Nexus 5K as core, How i can use my MAC Address Table list to create a MAC ACl that allows these MACs and block the rest? After doing this all new MACs should not be able to access the core switch, and i should be able to add and remo...

tiredes2015 · 08-04-2016

Hello, I have a Cisco 3800 with the below running config. Router>Router>Router>Router>Router>ENARouter>ENAbleRouter#SH RUNNRouter#SH RUNNing-configBuilding configuration... Current configuration : 1011 bytes!version 12.4service timestamps debug dat...

tiredes2015 · 02-01-2016

Hello, I am trying to configure Netflow on my Nexus 5624 Switch, Nx-os 7.2(1)N1(1) Here are the steps that i followed: switch(config)# feature netflow switch(config)# flow timeout active 60switch(config)# flow timeout inactive 15 switch(config)# f...

tiredes2015 · 07-18-2017

the problem is that i need to block MACs that are not directly conected to the 5K, the 5K is the gateway of all my Vlans, and there is many switches conected to it, I need to protect free network points (meeting rooms etc..) if anyone with person...

tiredes2015 · 08-04-2016

Worked perfectly. Thx for the help.

tiredes2015 · 08-04-2016

Hello Mark, Thank you for your reply. I tried the below with no success access-list 10 deny host 130.211.14.80 access-list 10 permit any Interface g0/0 Ip access-group 10 out Should i keep the access-list 1 permit any and add the above config at t...

tiredes2015 · 02-01-2016

Thank you AllertGen, This is really what was happening, I applied the netflow at Vlan INterface L3, and everythign went fine. I tried to activate the L2 netflow as well and worked fine. Thank you for thr hint. Cheers

Member Since	‎10-16-2015 07:41 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	8

User Statistics

User Activity

Allow only known MAC Addresses

access-list deny one destination

Config Netflow NX-OS

the problem is that i need to

Worked perfectly.

Hello Mark,

Thank you AllertGen,