Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have problem con EIGRP and two ASR 1001 in High Availability. ASR2 have received all route (100 route) from PE, but in ASR1 doesnt received all route (75 route) from PE or from other ASR02. All PE have all route. The ASR1 when modify or lost some ...
I have this configuration in a Router 2800. I need to know what functionality is first applied: "service policy input" or "crypto ipsec".interface FastEthernet0/0 description Conexion LAN ip address 10.33.84.1 255.255.255.0 speed 100 full-duplex cry...
We have an edge router (Cisco), and has a marking of packets based on DSCP. The edge router is connected to an ISP (not Cisco) which has a QoS based on IP Precedence. I understand that there is a conversion table between DSCP and IP Precedence, I won...
I have problems to configure CBWFQ on a ethernet sub-interface on a Cisco Router ASR 1001. Then I applied the policy in the physical interface but it should be is in the sub-interface. How can I configure CBWFQ on sub-interface in ASR 1001. (version...
This Bug CSCtx04709 is the problem. We have SIA routes in Topology Table (ASR1). See output show ip eigrp topolo all (ASR1):**************** suppressed output, ASR1 **************** A 10.2.1.15/32, 0 successors, FD is 5128448, Q, serno 3092414, ...
The router-id was planned and is different in the ASR and ASA. It may be a problem in EIGRP and used versions of IOS, see version in diagram. How can i determine this?