Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been working on IP SLA fail over and as soon as I get the fail over ISP to work I have not been able to get the primary to come back online. Any help is much appreciated.cisco#show runBuilding configuration...Current configuration : 6299 bytes...
I currently have Aironet 1040 AP that I am using stand alone. I am looking to have a second SSID for guest network. only problem I am having is how to get DHCP to those clients?
I still have no success. I believe the error to somehow be in the tracking object since when I show ip route track-table it returns that the state is down but this is not accurate.
regarding the next hop, yes. I was not exactly thorough when I cleansed the IP info. I have the next hop set to the gateway of ISP, not internal. I will try the config. I will be working on this today after 4:00 so if you are connected I would apprec...
Fail over actually works by sending it to the second route/interface. However the first default route will not work any longer. Even from a fresh boot up.
So I guess just to make sure I can accomplish this correctly I am attaching a quick diagram of my setup. I have two buildings connected by a wireless bridge. If I place a managed switch on just the side with the firewall is that sufficient or do I ne...
